Oculus go 死電池

alancck

轉quest2 囉，又唔係貴，依家買299重有128gb，
連淘佬都冇哩種電池，
一係買部二手爛go 換電池，

lnchu

網上好多upgrade 方法,不用拆開.外置尿袋插入叉電位用.我拆過結果買了部2仔.
https://www.youtube.com/watch?v=eMs_GmFhRLA

alancck

我拆過一部quest1改裝，
點都要有原裝電至開到機，
如果舊電直頭死咗，
插尿袋都開唔到機

lnchu

回覆 5# funlog
你睇唔明我這一句? "我拆過結果買了部2仔". 拆散了放棄. 就如#4電未死直,試插火牛work唔work/改用尿袋.

cocteau

我拆過一部quest1，
點都要有原裝電至開到機，
如果舊電直頭死咗，
插尿袋都開唔到機 ...
alancck 發表於 2021-12-11 15:21

我唸只係你郁左其他野先會開唔到機，go只係用一粒2600mAh 9.36Wh 3.6V既18650，好多人都換左，什至係咁換法：
https://i.imgur.com/Sx6dfst.jpeg

不過唔熟就唔好自己換喇，電池既野，搞錯好易燒。

cocteau

youtube 竟然無教學

via HKEPC Reader for Android
funlog 發表於 2021-12-12 11:35

因為多數人都係prefer尿袋，好少係粒電死。而且你既情況亦未必一定係死電，其他野壞都可以係插牛無反應。所以你要搞清楚壞咩，唔係既話換左電都一樣開唔著。

如果你真係想自己搞，參考下：
https://www.reddit.com/r/OculusG ... 34ah_will_relocate/


Teardown: https://youtu.be/eMs_GmFhRLA

Battery Info: The charging/power circuit board is spot welded to the battery. I peeled it off and soldered the wires to the leftover tabs.

I used a wireless electric drill to make holes at the top of the Go case and the battery case to route the wires.

I kept the battery case inside in order for the circuit board and wires to have a housing of sorts.

Just be careful is all. You can't remove the battery unless the connector is disconnected from the front.

IMHO important: Good soldering practice. I applied flux before soldering.

For my case attaching the battery does not allow me to immediately use it. Somehow I have to leave it to charge for 20 odd minutes. (My own non scientific reasoning may be some onboard power that needs charging LOL like the battery for motherboard?)

Be as gentle as possible. In my case I used 18 gauge wire. I'm not sure if this together with the length of wire causes the 20 min delay. Obviously in the default mode the battery is spot welded and right at the circuit so that seems to be super haha.